Aphex 5200 Instrukcja Użytkownika Strona 2

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 15
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 1
Network Settings
Each 1788A and 188 must be set to a different device ID number. (The Yamaha AD8HR ID
numbers are automatically set by the console, but this is not the case with the Aphex preamps.)
Youʼll need to keep track of the units network ID numbers so you can assign the digital inputs
from the preamp properly in the console. You will need to have the proper digital I/O option cards
installed in your Yamaha digital mixer for the Aphex preamps to plug in to. Please consult your
Aphex and Yamaha manuals for detailed information about digital inputs, digital outputs, pinouts
for connectors and word clock information.
For the 1788A follow these instructions:
MODE BUTTON
This selects which port handles remote control communications for the 1788A: MIDI or
LAN. No matter whether you are using the MIDI or the LAN port for remote control, you
must first put the Mode into MIDI in order to be able to change the Set I.D. parameters.
Once the Set I.D. parameters have been stored, you can change the Mode back to LAN
if appropriate.
Set I.D. How To Change The Channel, Device, and Net Numbers
This button steps through the three key unit identification parameters of Channel, Device
and Net numbers. The presently in effect values will appear in the Global Status
Readout.
When you need to set or change these values, you must go through the
Adjust/Store procedure as follows.
1. Press Local Control. The button will light up indicating you now have local control of
the 1788Aʼs front panel.
2. Set the Mode to MIDI.
3. Toggle the Set I.D. button to Channel, Device or Net - whichever is due to be updated.
4. Press Adjust/Store. It will light up.
5. Spin the ADJUST dial to set the correct number in the General Status Readout. Select
other I.D.s as desired and adjust their values.
6. When the desired numbers are updated, press Adjust/Store again to store the update.
The Adjust/Store button will go off indicating the values were stored and youʼre back in
safe mode.
7. Put the 1788A into the correct remote interface port by using the Mode button.
8. Press the REMOTE WAKEUP on the 5200.
Przeglądanie stron 1
1 2 3 4 5 6 7 ... 14 15

Komentarze do niniejszej Instrukcji

Brak uwag